Sequencing Controls - Watts AERCO Edge [ii] Operation Manual

Edge [ii] Controller Operation Manual
SECTION 6 – ADVANCED SETUP
Cascade Configuration). If the unit is configured as a BST Manager, the parameters apply to
this unit and all BST Client units.
Main Menu → Advanced Setup → BST Cascade → Operating
1. Go to:
Figure 6.3.4: BST Cascade: Operating Controls Screen

Sequencing Controls

The Sequencing Controls screen offers options related to sequencing of units in the plant.
NOTES:
•
This screen is available only after BST Cascade functionality has been enabled (see the
Unit Mode parameter in
as a BST Manager, the parameters apply to this unit and all BST Client units. If the unit
is configured as a BST Client, the parameters configured on the BST Manager will take
precedence.
The parameters that appear on this screen depend on the Application chosen in
•
Section 6.3.3: BST Application
Main Menu → Advanced Setup → BST Cascade → Operating Controls →
1. Go to:
Sequencing Controls.
Figure 6.3.4.1: Operating Controls: Sequencing Controls Screen
2. The parameters that appear on this screen depend which Application is chosen in
Section 6.3.3: BST Application Configuration
•
OMM-139_E 8/25/2020
Section 6.3.1: Cascade
Configuration.
and whether the unit is configured as a BST
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
Controls.
Configuration). If the unit is configured
Page 130 of 196