Restore Settings - Watts AERCO Edge [ii] Operation Manual

For benchmark boilers
Table of Contents

Advertisement

Edge [ii] Controller Operation Manual
SECTION 6 – ADVANCED SETUP
2. Chose where you want to save the current settings:
Onboard: Saves the current setup file to the Controller's onboard memory.
USB: This option is available only if an unencrypted USB device is plugged into the
Controller's USB port; if no USB device is plugged in, it is greyed-out, as shown above.
You can use the same USB device used in Section 6.2.7.1 to obtain the latest firmware.
NOTE:
Each unit produces a setup file with a unique name based on the unit's serial number. If that
setup file has already been saved to the Controller's memory or a USB device, this step will
overwrite it!
3. If the setup was successfully saved, the Save Succeeded screen appears; press Continue
to proceed. If it failed, a Save Unsuccessful screen appears. If successful, press Continue
to proceed.

Restore Settings

If you chose Restore All Settings or Restore Common Settings in Section 6.2.3, one of the
following screens appears:
Restore ALL Settings Option
Figure 6.2.3.2-1: Unit: Restore Source/Common Screens
1. Choose where the setup was saved (see
USB: If the setup was saved to a USB device plugged into the Controller's USB port.
Onboard: If the setup was saved to the Controller's onboard memory.
Factory Settings: Restores the original setup performed at the factory, overwriting
parameters that were manually configured after the unit was installed.
WARNING!
THIS STEP WILL OVERWRITE THE PREVIOUS SETUP!
OMM-139_E
8/25/2020
Section 6.2.3.1: Save
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
Restore COMMON Settings Option
Settings):
Page 100 of 196

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents