Ez Setup: Bst Manager - Other Application - Watts AERCO Edge [ii] Operation Manual

Edge [ii] Controller Operation Manual
SECTION 2: EZ SETUP
Enter the upper and lower limits of the DHW setpoint in the DHW Setpt Low
•
Limit and DHW Setpt Hi Limit fields.
•
Pressing Next takes you to the Select BAS Mode screen; skip to
Completing the Installation
Figure 2.3.2.1.2-5: BST Manager – DHW: DHW Analog Input Screen
4. If you chose Network or BAS, the Select BAS Mode screen appears. Skip to
Completing the Installation
2.3.2.1.3 EZ Setup: BST Manager – Other Application
Complete these instructions only if you chose Other at the end of Section 2.3.2.
Figure 2.3.2.1.3-1: BST Manager – Other: Select Your Boiler Application
1. The Other Operating Mode screen appears. Choose the operating mode for the "other"
application, either Constant Setpoint or Remote Setpoint, then press Next to continue.
Figure 2.3.2.1.3-2: BST Manager – Other: Other Operating Mode Screen
•
OMM-139_E 8/25/2020
for instructions.
for instructions.
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
Section 2.4:
Section 2.4:
Page 39 of 196