Subsystem - Watts AERCO Edge [ii] Operation Manual

Edge [ii] Controller Operation Manual
SECTION 3: CALIBRATION
7. If the output selected in Step 2, includes feedback, it is displayed in the Feedback
parameter (see the Name parameter in
sensed, the reading is '---'(blank). The feedback signal mapping is:
Analog Output
Cascade Valve
BLR VS (Variable Speed) Pump
DHW VS (Variable Speed) Pump
8. Repeat Steps 2 through 7 with the other Analog Outputs in use in the system.

3.4 Subsystem

The Subsystem screen provides access to two system components:
•
The Air/Fuel Valve
•
The Spark Monitor
Figure 3.4: Calibration: Subsystem Calibration Menu
Main Menu → Calibration →
1. Go to:
2. Press either Air Fuel Valve or Spark Monitoring.
NOTE:
You can navigate between the Air Fuel Valve and Spark Monitor screens in round-robin fashion
using the Page Left and Page Right icons on both screens.
•
OMM-139_E 8/25/2020
Section 6.5.4: Analog
Analog Input (Feedback)
Cas Vlv Fdbk
BLR VSP Fdbk
DHW VSP Fdbk
Subsystem.
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
Inputs). If no feedback is
Display Tag
Valve Feedback
Pump Feedback
Pump Feedback
Page 71 of 196