Download Directly To The Controller - Watts AERCO Edge [ii] Operation Manual

Edge [ii] Controller Operation Manual
SECTION 6 – ADVANCED SETUP
If you are an ATT or AMT, complete the following instructions to obtain the latest Edge firmware.
1. Plug the USB device into an external computer that can write to un-encrypted USB devices.
2. Go to the following URL:
3. If you do not already have an account on this site, create one before continuing.
4. Scroll down the left navigation pane and open the Edge Firmware folder.
5. Copy the Edge Controller firmware file(s) (see
the root directory of your USB device, not a sub-folder. If the folder contains updated
Graphics, I/O Board and/or Display files, copy all these files to the root directory without
changing their names (unless instructed to do so). If your unit has a BootLoader version
prior to V1.00, you must download the file named edgeImage.hex.
NOTE:
If your unit(s) all have the new Intelligent BootLoader (V1.00 or later), both Innovation and
Benchmark files can be copied on to the same USB device. The download only needs to be
performed once on a single USB device; that device can then be used to update all boilers
and/or all water heaters.
6. You are now ready to update the Controller. Skip to
Controller's
Firmware. If needed, refer to the release notes for a running revision history.

Download Directly to the Controller

Complete the instructions below to download the latest firmware directly into the USB device
plugged into the side of Controller. This option requires an un-encrypted USB device and an
Ethernet cable capable of reaching the unit. Once the new firmware is copied to the USB
device, it will be loaded into the Controller in
Firmware. Note, this method saves the Innovation or Benchmark firmware update file(s) that are
compatible with the Intelligent BootLoader V1.00 or later to the USB device. If you are updating
a unit with an older BootLoader, it will save the file edgeImage.hex to the USB device.
1. Remove the unit's front panel, to expose the USB port on the Controller's left side.
2. Insert an un-encrypted USB device in the USB port.
3. Plug an active Ethernet cable in the Ethernet port.
USB PORT
ETHERNET PORT
4. Set the Enable/Disable switch on the Controller's front face to the Disable position.
•
OMM-139_E 8/25/2020
http://learning.aerco.com.
Section 6.2.7
Section 6.2.7.4: Updating the Controller's
Figure 6.2.7.3-1: USB Port Location
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
for the naming convention) to
Section 6.2.7.4: Updating the
Page 111 of 196