Watts AERCO Edge [ii] Operation Manual page 126

Edge [ii] Controller Operation Manual
SECTION 6 – ADVANCED SETUP
TABLE 6.6: Application =
DHW Setpoint
DHW Rmt Setpt Signal
DHW Rem Setpt Source (If DHW Rem Setpt Signal = 1-5V or 0-5V)
DHW Pump Unit Address
DHW Setup
DHW Pump Control Type
DHW Pump Off Time
DHW Aquastat Enable (if DHW Setup = 2 or 4 Port Tank)
Aquastat Unit Addr (if DHW Aquastat Enable = Enabled)
DHW Setpoint Offset
Setpoint Ramp Rate
TABLE 6.7: Application =
Other Rmt Setpt Signal
Other Rmt Setpt Source (if Other Rem Setpt Signal = 1-5V or 0-5V)
Other Setpoint
NOTE:
The following tables show the parameters that are unique to these Applications. However, all
the Applications below also include the parameters in the SH, DHW and/or Other
Application tables above if the Application includes SH, DHW or Other.
TABLE 6.8: Application =
Application =
Unit 1 Designation, up to
Unit 16 Designation
Default Swing Boiler Load
SH Swg Vlv Unit Add
DHW Swg Vlv Unit Add
SH Valve Open Time
DHW Valve Open Time
TABLE 6.9: Application = Other+SH-Stpt Prty
Other SH PRI Setpt Mode
Other SH PRI Setpoint (if Other SH PRI Setpt Mode = Constant Setpoint)
Other SH PRI Remote Signl (if Other SH PRI Setpt Mode = Remote Setpoint)
•
OMM-139_E 8/25/2020
DHW
DHW Operating Mode =
Other
Other Operating Mode =
SH+DHW-1-Vlv and SH+DHW-2-Vlv
SH+DHW-1-Vlv
✓
✓
✓
✓
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
Constant
Setpoint
✓
✓
✓
✓
✓
✓
✓
✓
✓
Constant
Setpoint
✓
SH+DHW-2-Vlv
✓
✓
✓
✓
✓
✓
Remote
Setpoint
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
Remote
Setpoint
✓
✓
Page 126 of 196