Watts AERCO Edge [ii] Operation Manual page 50

Edge [ii] Controller Operation Manual
SECTION 2: EZ SETUP
6. If you chose Remote Setpoint in step 4, the Select Remote Setpoint Type screen
appears. Choose how the unit will access the setpoint, then press Next.
Figure 2.3.2.2.2-8: BST Manager – DHW & Other: Select Remote Setpoint Type
A. If you chose either 4-20mA or 0-20mA, the Other Analog Input screen appears.
Configure the following parameters. Pressing Next takes you to the Select BAS
Mode screen; skip to
Choose the remote setpoint source in the Other Rmt Setpt Source field (a
•
green border appears on the previous choice, if there was one): Spare Analog
in 1, Spare Analog in 2, Spare Analog in 3.
Enter the upper and lower limits of the "other" setpoint in the BST Other
•
Setpt Lo Limit and BST Other Setpt Hi Limit fields.
•
Pressing Next takes you to the Select BAS Mode screen; skip to
Completing the Installation
Figure 2.3.2.2.2-9: BST Manager – DHW & Other: Other Analog Input Screen
B. If you chose Network, the Select BAS Mode screen. Skip to
Completing the Installation
•
OMM-139_E 8/25/2020
Section 2.4: Completing the Installation
for instructions.
for instructions.
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
for instructions.
Section 2.4:
Section 2.4:
Page 50 of 196