Table of Contents
Advertisement
Edge [ii] Controller Operation Manual
SECTION 6 – ADVANCED SETUP
6.2.1 Unit Settings
The Unit Settings screens displays a list of parameters and controls on several pages. Many of
the parameters were set at the factory before shipping and should not be changed.
Main Menu → Advanced Setup → Unit → Unit
1. Go to:
2. The following fields are available:
Unit Serial #: Displays the unit's factory-set serial number in a unique format of G-
•
YY-ZZZZ or N-YY-ZZZZ. Do NOT change except if replacing the Edge Controller. The
format is:
o G: A letter specific to Benchmark 750-4000 boilers and Innovation Water
Heaters. The letter N is specific to Benchmark 5000 & 6000 boilers.
o YY: The two-digit year
o ZZZZ: A sequential 4-digit serial number.
Unit Type: Displays AERCO products and models. Do NOT change except if
•
replacing the Edge Controller.
• KC Boiler
• BMK Boiler Std
• BMK Boiler LN
Unit Size: Displays available sizes for the given Unit Type. Do NOT change unless
•
replacing the Edge Controller.
Control Type: Specifies the controller: Edge [ii] (the default for all Platinum units) or
•
Edge [i]. Do NOT change unless replacing the Edge Controller with an Edge [i]
Controller.
•
OMM-139_E
8/25/2020
Figure 6.2.1-1: Unit: Unit Settings Screens
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
Settings.
• KC Boiler LN
• BMK Boiler Std Dual
• BMK Boiler LN Dual
Page 95 of 196
Hide quick links:
Advertisement
Table of Contents
