Ez Setup: Bst Manager - Space Heating And Other Applications - Watts AERCO Edge [ii] Operation Manual

Edge [ii] Controller Operation Manual
SECTION 2: EZ SETUP
2.3.2.2.3 EZ Setup: BST Manager – Space Heating and Other Applications
Complete these instructions only if you chose both Space Heating and Other at the end of
Section 2.3.2.
Figure 2.3.2.2.3-1: BST Manager – SH & Other: Select Your Boiler Application
1. The SH Operating Mode screen appears. Choose the desired operating mode, then press
Next to continue.
Figure 2.3.2.2.3-2: BST Manager – SH & Other: SH Operating Mode
NOTES:
•
If the outdoor air sensor is not connected, the OAT (Outdoor Air Temperature) parameter
is disabled.
•
If the header sensor is not connected, the bottom of the screen will display HDR = --- °F.
For the header sensor to function without previous setup, the default for HDR sensor must
be sensor enabled and the source is Direct. For information on adjusting the defaults see
Section 6.3.1 Cascade
•
OMM-139_E 8/25/2020
Configuration.
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
Page 51 of 196