Ez Setup: Bst Manager Unit - Watts AERCO Edge [ii] Operation Manual

Edge [ii] Controller Operation Manual
SECTION 2: EZ SETUP

2.3.2 EZ Setup: BST Manager Unit

The Manager unit will sync with all Client boilers once this process is completed. Note, if a BST
Manager setup was already performed on this or another unit, and you want to load/re-load that
Section 2.5: EZ Setup – Restoring a Previous
setup, see
NOTE:
All "Client" units are typically setup before starting the BST Manager setup, so their addresses
are available during this process. If they are not all setup, you will have to pause and setup all
Client units before completing the BST Manager setup.
Main Menu → EZ
1. Go to:
2. If the unit was previously setup, the EZ Setup screen appears showing a summary of the
previous setup (see Figure 2.3.1-1, above). You can Abort and retain the previous setup or
press Next to continue.
3. On the Select Configuration screen press BST Cascade, then press Next.
Figure 2.3.2-2: BST Manager: Select Configuration Screen
4. On the Cascade Role screen select BST Manager and then press Next. The Manager LED
will light on the front panel signifying the role of the unit.
Figure 2.3.2-3: BST Manager: Cascade Role Screen
•
OMM-139_E 8/25/2020
Setup.
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
Setup.
Page 31 of 196