Section 6: Advanced Setup - Watts AERCO Edge [ii] Operation Manual

Edge [ii] Controller Operation Manual
SECTION 6 – ADVANCED SETUP

SECTION 6: ADVANCED SETUP

The Advanced Setup screen provides access to specific parameters. It is accessed by
pressing Advanced Setting on the Main Menu.
This Section includes the following topics:
6.1: Access
6.2: Unit
6.2.1: Unit Settings
6.2.2: Front Panel Configuration
6.2.3: Save and Transfer Settings
6.2.4: Fault Management
6.2.5: Freeze Protection
6.2.6: Unit Application Configuration
6.2.7: Firmware Update
6.2.8: Maintenance
6.3: BST Cascade
6.3.1: Cascade Configuration
6.3.2: Cascade Communication
6.3.3: BST Application Configuration
6.3.4: Operating Controls
6.3.4.1: Sequencing Controls
6.3.4.2: Anti-Cycling Control
6.3.4.3: Temperature Control
6.3.4.4: Valve Configuration
6.3.4.5: Reserve Unit Control
6.3.4.6: Setpoint Range
6.3.4.7: Lead/Lag
6.3.4.8: Valve Balancing
6.3.5: SmartPlate Communication
WARNING:
Before starting the instructions in this section for the first time, you must ensure that the unit
has the latest Edge Controller firmware. Complete the instructions in
Update to obtain and install the latest firmware.
•
OMM-139_E 8/25/2020
Figure 6.0: Advanced Setting Screen
6.4: Comm & Network
6.5: Ancillary Device
6.6: Performance
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
6.4.1: BAS (Building Automation System)
6.4.2: onAER
6.4.3: Smart Devices
6.4.4: Ethernet
6.4.5: Communication Failsafe
6.5.1: Interlocks
6.5.2: Relays
6.5.3: Analog Outputs
6.5.4: Analog Inputs
6.6.1: AERtrim
6.6.1.1: AERtrim Settings
6.6.1.2: O2 Trim Parameters
6.6.1.3: AERtrim Status
6.6.2: Temperature Controls
6.6.2.1: PID Setting
6.6.2.2: Temperature Conformance
6.6.2.3: Setpoint Range
6.6.3: Fire Control
6.6.3.1: Purge Control
6.6.3.2: Ignition Control
6.6.3.3: Operation Control
6.6.3.4: Anti-Cycling Control
Section 6.2.7: Firmware
Page 93 of 196