Aertrim; Aertrim Settings - Watts AERCO Edge [ii] Operation Manual

Edge [ii] Controller Operation Manual
SECTION 6 – ADVANCED SETUP

6.6.1 AERtrim

The AERtrim screen provides access to AERtrim settings, O
status parameters. Note, the parameters in those screens are not available until AERtrim has
been successfully activated in the AERtrim Settings screen (see Section 6.6.2, below).
Main Menu → Advanced Setup → Performance →
1. Go to:
NOTE:
You can navigate from one AERtrim screen to the next in round-robin fashion using the Page
Left and Page Right icons on each screen.

AERtrim Settings

AERtrim functionality is enabled/disabled and configured on this unit from the AERtrim
Settings screen.
NOTES:
AERtrim must be activated before it can be enabled. It is activated on all Benchmark Platinum
units before they are shipped. If a new controller is installed, it must be reactivated, which
requires entry of the Activation Code, created by AERCO specifically for each unit. This
process can be initiated from this screen, but you must have the Activation Code to complete
the process. Each Activation Code is based on the serial number of the unit, and is therefore
specific to that unit only. Once AERtrim has been successful activated, AERtrim can be
disabled and re-enabled without having to re-activate it.
AERtrim functionality is automatically disabled if the O
•
OMM-139_E 8/25/2020
Figure 6.6.1: Performance: AERtrim Screen
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
Trim Parameters and AERtrim
2
AERtrim.
sensor is removed or faulted.
2
Page 156 of 196