Aborting An Action - Watts AERCO Edge [ii] Operation Manual

Edge [ii] Controller Operation Manual
SECTION 1: INTRODUCTION
To make a selection in a user-selectable parameter, press on the field you want to change (the
word Select in the figure below); a list of options appears. When you select an option, the
original screen reappears with your selection displayed in the field.

1.10 Aborting an Action

The abort action is available when a process has begun but may need to be terminated prior to
completion. This is initiated by pressing the Abort button, if available, or pressing the Home
button in the touchscreen's upper-right corner.
The following occurs when a process is aborted:
1. A confirmation screen appears. Select Yes to abort the process. If no action is taken within
15 seconds, or if you select No, the abort is cancelled, and the process continues.
2. When an abort is successful, the process terminates, and you are returned to the original
screen. When an abort is performed on a screen that has multiple items, items that were
entered up to that point are saved.
3. If the process completes while the Abort confirmation screen is displayed, the Abort action is
nullified.
•
OMM-139_E 8/25/2020
Figure 1.9-4: List Controls
Figure 1.10: Abort Confirmation Screen
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
Page 14 of 196