Ez Setup: Standalone - Other Application - Watts AERCO Edge [ii] Operation Manual

Edge [ii] Controller Operation Manual
SECTION 2: EZ SETUP
takes you to the Select BAS Mode screen; skip to
Installation
Figure 2.2.2-6: Standalone – DHW: Comm Settings Screen
C. If you chose BAS, the Select BAS Mode screen appears. Skip to
Completing the Installation
2.2.3 EZ Setup: Standalone – Other Application
Complete these instructions only if you chose Other at the end of Section 2.2.
Figure 2.2.3-1: Standalone – Other: Select Your Boiler Application Screen
1. The Other Operating Mode screen appears. Choose the Other Operating Mode (its
square turns green) then press Next to go to that option's screen.
•
If you chose Constant Setpoint, proceed to Step 2.
•
If you chose Remote Setpoint, skip to Step 3.
Figure 2.2.3-2: Standalone – Other: Other Operating Mode Screen
•
OMM-139_E 8/25/2020
for instructions.
for instructions.
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
Section 2.4: Completing the
Section 2.4:
Page 26 of 196