Watts AERCO Edge [ii] Operation Manual page 58

For benchmark boilers
Table of Contents

Advertisement

Edge [ii] Controller Operation Manual
SECTION 2: EZ SETUP
Main Menu → EZ Setup
1. Go to:
described above.
2. After the first few steps, when the Load Settings screen appears, press Yes.
Figure 2.4-1: EZ Setup: Load Settings Screen
3. The Settings File Select screen appears. Choose the location of the setup file:
If the settings are on a USB device, choose USB.
If the settings are in the Controller's on-board memory, choose Onboard.
If you want to restore the original factory settings, choose Factory Settings.
Figure 2.4-2: EZ Setup: Settings Source Select Screen
4. The Overwrite Calibration screen appears. Press Yes or No to proceed. Pressing Yes will
overwrite the unit's existing combustion calibration setting, while pressing No will retain
those settings.
Figure 2.4-3: EZ Setup: Settings Upload Complete Screen
OMM-139_E
8/25/2020
and start any of the EZ Setup configuration routines
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
Page 58 of 196

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents