Preparing For Firmware Update - Watts AERCO Edge [ii] Operation Manual

Edge [ii] Controller Operation Manual
SECTION 6 – ADVANCED SETUP
A Benchmark Boiler equipped with the Intelligent BootLoader will look for the Benchmark files
and always pick Item #3, the BMK firmware file with the most recent version number. An
Innovation Water Heater will look for and always pick item #4, the Innovation firmware file.
NOTE:
The Intelligent BootLoader is backward compatible with earlier firmware versions; it will load
firmware files named edgeImage.hex if it can't find the relevant BMK or INN file.
In addition, the Unit Settings screen now contains a Product Type parameter, which
displays either BMK or INN, depending on which firmware type is currently loaded.

Preparing for Firmware Update

Complete the following steps to save the unit's current setup, which includes the current state of
all settings/parameters. The setup will be restored only if necessary, as described in
6.2.7.5.
1. Remove the unit's front panel, to expose the USB port on the Controller's left side.
2. On the Edge Controller, go to:
Transfer.
Figure 6.2.7.1-1: Unit: Settings Transfer Screen
3. Choose Save All Settings; the Save Destination screen appears.
4. Chose where you want to save the current setup:
•
Onboard: Saves the current setup file to the Controller's onboard memory.
•
OMM-139_E 8/25/2020
Main Menu → Advanced Setup → Unit → Settings
Figure 6.2.7.1-2: Unit: Save Source Selection
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
Section
Page 109 of 196