Table of Contents
Advertisement
Edge [ii] Controller Operation Manual
SECTION 6 – ADVANCED SETUP
Restore Settings After Firmware Update
If the spot check in the previous section failed, you should restore the setup and its parameters
to their original state prior to the update.
Main Menu → Advanced Setup → Unit → Settings
1. Go to:
2. Choose Restore All Settings; the Restore Source screen appears.
3. Choose where you saved the setup (in
•
USB if the same USB device is still plugged in.
•
Onboard If the setup was saved to the Controller's onboard memory.
4. The Overwrite Calibration screen now appears. Press Yes to overwrite the existing
combustion calibration values or press No to retain the existing values.
•
OMM-139_E
8/25/2020
Figure 6.2.7.5-1: Settings Transfer Screen
Figure 6.2.7.5-2: Restore Source Screens
Section
Figure 6.2.7.5-3: Load Settings Screen
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
Transfer.
6.2.7.3), then press either:
Page 114 of 196
Hide quick links:
Advertisement
Table of Contents
