Table of Contents
Advertisement
When the Edge and Glitch assignment field is selected, an assignment pop-up
appears showing you the bit or channel to be assigned, and the five choices
directly above it.
Edge and Glitch Selection List
Press the
Up/Down arrow
3
assignment, then press the
the cursor to the next channel. Repeat step 3 until all of the desired
channels are assigned.
To close the assignment field, press the
4
Individual bits or channels are cleared by pressing the front-panel (.) period
key. The entire bank of channels are cleared by pressing the Clear entry key.
It should be noted that when you close the pop-up after specifying edges, you
see dollar signs ($ $ ... ) in the assignment field. This simply indicates the
logic analyzer can't display the assignment correctly in the current number
base selected.
Using the Front-Panel Interface
How to Use Assignment/Specification Menus
keys to move the cursor to the desired edge
left/right arrow
key or turn the knob to move
key.
Done
Edge and glitch
selection list
3–29
Advertisement
Table of Contents
