Changing The Line Voltage Setting - Agilent Technologies 4286A User Manual

1. Place the collet on the center
conductor of the connector.

Changing the Line Voltage Setting

The line voltage selector is set at the factory to correspond to the most commonly used line
voltage of the country of destination. The line voltage selected for the meter is indicated on
the line voltage selector. Refer to table Table B-1 for the line voltage ranges. Perform the
following steps to change the line voltage:
Remove the power cord if it is connected. Open the cover of AC line receptacle on
B-4 Maintenance
2. Press the collet gently until it snaps
into place.
Table B-1. Line Voltage Ranges
AC Voltage Range Selector Voltage
90 V to 132 V
198 V to 264 V
the rear panel using a small, at-blade
screwdriver.
115 V
230 V