Select Sys PV, then select Analy PV in the pop-up menu. Select Chip
11
2 Tests.
You can run all the analyzer tests at one time by selecting All Analyzer Tests.
To see more details about each test, you can run each test individually. This
example shows how to run Chip 2 Tests. Chip 3, 4, and 5 Tests operate the
same as Chip 2 Tests.
In the Chip 2 Tests menu, select Run, then select Single. The test
12
runs one time, then the screen shows the results. When the test is
finished, select Done. Then, perform the other Chip Tests.
To run a test continuously, select Repetitive. Select Stop to halt a Run
Repetitive.
Operator's Service
To run the self-tests (1660A through 1663A)
20-17