Table of Contents
Advertisement
To apply power
Electrostatic discharge can damage electronic components. Use grounded
C A U T I O N
wriststraps and mats when performing any service to the logic analyzer.
Check that the line voltage selector, located on the rear panel, is on
1
the correct setting and the correct fuse is installed.
See also, "To set the line voltage" on the next page.
Connect the power cord to the instrument and to the power source.
2
This instrument is equipped with a three-wire power cable. When connected
to an appropriate ac power outlet, this cable grounds the instrument cabinet.
The type of power cable plug shipped with the instrument depends on the
country of destination.
Turn on the instrument power switch located on the front panel.
3
To operate the user interface
To select a field on the logic analyzer screen, use the arrow keys to
highlight the field, then press the Select key. For more information
about the logic analyzer interface, refer to chapter 7.
To set the GPIB address or to configure for RS-232C or Centronix,
refer to chapter 7.
20-6
Advertisement
Table of Contents
