Using Macros to Create a Trigger Specification
To configure a trigger specification using trigger macros, follow the
procedure below.
From the Trigger menu, enter the desired sequence level through the
1
Modify Trigger
See Also
"Editing Sequence Levels" and "Modify Trigger Field" found earlier in this
chapter for information on accessing levels.
From within the sequence level, select the
2
Select New Macro Field
Scroll and highlight the macro you want, then select the
3
Select the appropriate assignment fields and insert the desired
4
pre-defined resource terms, numeric values, and other parameter
fields required by the macro. Select the
In State Acquisition mode, a final "go to trigger" level is automatically placed
at the end of the trigger specification for you.
See Also
"Resource Terms" found later in this chapter for information on using
pre-defined resource terms.
Using Macros to Create a Trigger Specification
field, or by selecting a sequence level number.
Select new macro field
The Trigger Menu
field.
Select New Macro
Assignment field
Select
field.
Done
field.
12–13