Displaying And Debugging Link Aggregation - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide

7.3 Displaying and Debugging Link Aggregation

After the above configuration, execute the display command in any view to display the
running of the link aggregation configuration, and to verify the effect of the
configuration.
In user view, execute the reset command to clear statistics on the LACP-enabled port,
and the debugging command to enable LACP debugging.
Table 7-7 Display and debug link aggregation
Display summary information of all
aggregation groups
Display detailed information of a specific
aggregation group
Display the local device ID
Display
information at the port
Clear LACP statistics on the port
Disable/enable LACP state debugging
Disable/enable LACP packet debugging
Disable/enable link aggregation error
debugging
Disable/enable link aggregation event
debugging
Operation
detailed link aggregation
Chapter 7 Link Aggregation Configuration
display link-aggregation summary
display link-aggregation
agg-id
display lacp system-id
display link-aggregation
{ interface-type
interface-name } [ to { interface-type
interface-num | interface-name } ]
reset lacp
{ interface-type
interface-name } [ to { interface-type
interface-num | interface-name } ] ]
[ undo ]
[ interface
interface-number | interface-name } [ to
{ interface-type
interface-name } ] ] { { actor-churn |
mux | partner-churn | ptx | rx }* | all }
[ undo ] debugging lacp packet
[ interface
interface-number | interface-name } [ to
{ interface-type
interface-name } ] ]
[ undo ] debugging link-aggregation
error
[ undo ] debugging link-aggregation
event
7-9
Command
verbose
interface
interface-number
statistics [ interface
interface-number
debugging lacp state
{ interface-type
interface-num
{ interface-type
interface-num
|
|
|
|