Sending The Configuration Information To The Log Buffer - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
This configuration will affect the timestamp of the displayed information.
Perform the following configuration in system view:
Table 46-32 Configure the output format of time-stamp
Configure the output format of the
time-stamp
Output time-stamp is disabled
4) Enabling terminal display function
To view the output information at the Telnet terminal or dumb terminal, you must first
enable the terminal display function, and then the corresponding terminal display
function of log information on the switch.
For example, if you have set the log information as the information sent to the Telnet
terminal or dumb terminal, now you need to use the terminal monitor command to
enable the terminal display function and the terminal logging command to enable the
terminal display function of log information on the switch, then you can view the
information at the Telnet terminal or dumb terminal.
Perform the following configuration in user view:
Table 46-33 Enable terminal display function
Enable terminal display function of log, debugging
and trap information
Disable terminal display function of the above
information
Enable terminal display function of debugging
information
Disable terminal display function of debugging
information
Enable terminal display function of log information
Disable terminal display function of log information
Enable terminal display function of trap information
Disable terminal display function of trap information

46.5.6 Sending the Configuration Information to the Log Buffer

To send configuration information to the log buffer, follow the steps below:
Operation
Operation
46-21
Chapter 46 System Maintenance and Debugging
Command
info-center timestamp { log | trap |
debugging } { boot | date | none }
undo info-center timestamp { log |
trap | debugging }
terminal monitor
undo terminal monitor
terminal debugging
undo terminal debugging
terminal logging
undo terminal logging
terminal trapping
undo terminal trapping
Command