Setting The Destination Address Of Trap; Setting Lifetime Of Trap Message - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
Table 47-4 Enable/disable SNMP Agent to send Trap
Enable the sending of trap(system view)
Disable the sending of trap(system view)
Enable the switch ports to send SNMP
trap messages (Ethernet port view or
VLAN interface view)
Disable the switch port to send SNMP
trap messages (Ethernet port view or
VLAN interface view)
By default, the current port or VLAN interface sends trap messages.

47.3.4 Setting the Destination Address of Trap

You can use the following commands to set or delete the destination address of the
trap.
Perform the following configuration in system view.
Table 47-5 Set the destination address of trap
Set the destination address of trap
Delete the destination address of
trap

47.3.5 Setting Lifetime of Trap Message

You can use the following command to set lifetime of Trap message. Trap message that
exists longer than the set lifetime will be dropped.
Perform the following configuration in system view.
Operation
Operation
47-5
Chapter 47 SNMP Configuration
Command
snmp-agent trap enable [ standard
[ authentication
[ linkdown ] [ linkup
[ backwardtransition ] [ established ] |
vrrp [ authfailure | newmaster ] ]
undo snmp-agent
[ standard [
[ coldstart ] [ linkdown ] [ linkup ] | bgp
[ backwardtransition ] [ established ] |
vrrp [ authfailure | newmaster ] ]
enable snmp trap updown
undo enable snmp trap updown
Command
snmp-agent target-host trap address
udp-domain host-addr
udp-port-number ] params securityname
community-string [
[ authentication | privacy ] ]
undo snmp-agent target-host host-addr
securityname community-string
] [ coldstart ]
] | bgp
trap enable
authentication ]
[ udp-port
v1 | v2c | v3