3Com 8800 Configuration Manual page 713

3Com Switch 8800 Configuration Guide
II. Network diagram
129.102.149.23
NMS
Figure 47-2 Network diagram for SNMP configuration
III. Configuration procedure
Enter the system view.
<SW8800> system-view
Set the community name, group and user.
[SW8800] snmp-agent sys-info version all
[SW8800] snmp-agent community write public
[SW8800] snmp-agent mib include internet 1.3.6.1
[SW8800] snmp-agent group v3 managev3group write internet
[SW8800] snmp-agent usm v3 managev3user managev3group
Set the VLAN interface 2 as the interface for network management. Add port
GigabitEthernet 2/1/3 to the VLAN 2. This port will be used for network management.
Set the IP address of VLAN interface 2 as 129.102.0.1.
[SW8800] vlan 2
[SW8800-vlan2] port gigabitethernet 2/1/3
[SW8800-vlan2] interface vlan 2
[SW8800-Vlan-interface2] ip address 129.102.0.1 255.255.0.0
Enable SNMP agent to send the trap to network management station whose IP address
is 129.102.149.23. The SNMP community is public.
[SW8800] snmp-agent trap enable standard authentication
[SW8800] snmp-agent trap enable standard coldstart
[SW8800] snmp-agent trap enable standard linkup
[SW8800] snmp-agent trap enable standard linkdown
[SW8800] snmp-agent target-host trap address udp-domain 129.102.149.23
udp-port 5000 params securityname public
IV. Configure network management system
The PC on which the network management resides requires for login configuration. As
for Mib-Browser, the login configuration is as follows: SNMPV1/V2 logs in using the
default community name public, and the SNMPV3 logs in using managev3user.
129.102.0.1
Ethernet
47-10
Chapter 47 SNMP Configuration