Creating/Deleting A Local Radius Authentication Server; Configuring Tacacs+ Protocol - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
By default, the default data unit is byte and the default data packet unit is one packet.

40.3.15 Creating/Deleting a Local RADIUS authentication Server

RADIUS service, which adopts authentication/authorization/accounting servers to
manage
authentication/authorization service is also used in these products and it is called local
RADIUS function, i.e. realize basic RADIUS function on the switch.
Perform the following configuration in system view.
Table 40-25 Creating/Deleting a local RADIUS authentication server
Create a local RADIUS authentication
server
Delete a local RADIUS authentication
server
By default, the IP address of local RADIUS authentication server group is 127.0.0.1 and
the password is 3Com.
When using local RADIUS server function, note that,
1) The number of UDP port used for authentication/authorization is 1645 and that for
accounting is 1646.
2) The password configured by local-server command must be the same as that of
the RADIUS authentication/authorization packet configured by the command key
authentication in radius scheme view.
3) The Switch 8800 serving as a local RADIUS authentication server currently only
supports the CHAP and PAP authentication modes; they do not support the
MD5-challenge mode.

40.4 Configuring TACACS+ Protocol

The following sections describe TACACS+ configuration tasks.
Creating a HWTACAS Scheme
users, is widely
Operation
Chapter 40 AAA and RADIUS/TACACS+ Protocol Con
used in the Switch
local-server nas-ip ip-address key
password
undo local-server nas-ip ip-address
40-22
figuration
8800. Besides,
Command
local