3Com 8800 Configuration Manual page 688

3Com Switch 8800 Configuration Guide
Note:
Info-center is enabled by default. After info-center is enabled, system performances are
affected when the system processes much information because of information
classification and outputting.
2) Configuring to output information to console terminal
Perform the following configuration in system view.
Table 46-25 Configure to output information to console terminal
Output information to Console
Cancel
outputting information to Console
3) Configuring information source on the switch
By this configuration, you can define the information that sent to console terminal is
generated by which modules, information type, information level, and so on.
Perform the following configuration in system view:
Table 46-26 Define information source
Define information source
Cancel the configuration of
information source
modu-name specifies the module name; default represents all the modules; all
represents all the information filter configuration in channelnum chunnel except default;
level refers to the severity levels; severity specifies the severity level of information.
The information with the level below it will not be output. channel-number specifies the
channel number and channel-name specifies the channel name.
When defining the information sent to the console terminal, channel-number or
channel-name must be set to the channel that corresponds to Console direction.
Every channel has been set with a default record, whose module name is default and
the module number is 0xffff0000. However, for different channels, the default record
Operation
the configuration
Operation
Chapter 46 System Maintenance and Debugging
info-center
{ channel-number | channel-name }
of
undo info-center console channel
Command
info-center source { modu-name | default }
channel { channel-number | channel-name }
[ debug { level severity | state state }* | log { level
severity | state state }* | trap { level severity | state
state }* ]*
undo info-center source { modu-name | default |
all } channel { channel-number | channel-name }
46-17
Command
console channel