3Com 8800 Configuration Manual page 128

3com 8800: install guide

Hide thumbs Also See for 8800:

Table of Contents

3Com Switch 8800 Configuration Guide

DHCP server, is supposed to assign IP addresses to the two DHCP clients without the

help of any DHCP Relay.

II. Network diagram

Sw itch ( DHCP Server)

Figure 13-2 Network diagram for DHCP server

III. Configuration procedure

Enter system view.

<SW8800>system-view

Create VLAN2.

[SW8800]vlan 2

Enter VLAN interface view and create Vlan-interface 2.

[SW8800]interface Vlan-interface 2

Assign an IP address to Vlan-interface 2.

[SW8800-Vlan-interface2]ip address 10.110.1.1 255.255.0.0

Specify to assign IP addresses in the interface address pool to DHCP clients.

[SW8800-Vlan-interface2]dhcp select interface

Specify to assign IP addresses in global address pool to DHCP clients (it is also the

default configuration).

[SW8800-Vlan-interface2]dhcp select global

Or execute the following command to revert to the default.

[SW8800-Vlan-interface2]undo dhcp select

Configure a global address pool.

[8505Tlhy]dhcp server ip-pool 1

[8505Tlhy-dhcp-1]network 10.110.0.0 mask 255.255.0.0

[8505Tlhy-dhcp-1]gateway-list 10.110.1.1

DHCP cli e nt

Chapter 13 DHCP Configuration

Troubleshooting