3Com 8800 Configuration Manual page 695

3Com Switch 8800 Configuration Guide
Disable info-center
Note:
Info-center is enabled by default. After info-center is enabled, system performances are
affected when the system processes much information because of information
classification and outputting.
2) Configuring to output information to the trap buffer
Perform the following configuration in system view.
Table 46-39 Configure to output information to trap buffer
Output information to trap buffer
Cancel
outputting information to trap buffer
3) Configuring information source on the switch
By this configuration, you can define the information that sent to trap buffer is generated
by which modules, information type, information level, and so on.
Perform the following configuration in system view:
Table 46-40 Define information source
Define information source
Cancel the configuration of
information source
modu-name specifies the module name; default represents all the modules; all
represents all the information filter configuration in channelnum chunnel except default;
level refers to the severity levels; severity specifies the severity level of information.
The information with the level below it will not be output. channel-number specifies the
channel number and channel-name specifies the channel name.
When defining the information sent to trap buffer, channel-number or channel-name
must be set to the channel that corresponds to trapbuffer direction.
Operation
the configuration
Operation
info-center source { modu-name | default }
channel { channel-number | channel-name } [ debug
{ level severity | state state }* | log { level severity |
state state }* | trap { level severity | state state }* ]*
undo info-center source { modu-name | default |
all } channel { channel-number | channel-name }
Chapter 46 System Maintenance and Debugging
undo info-center enable
info-center trapbuffer [ size buffersize |
channel {
channel-name } ]*
of undo info-center trapbuffer [ channel |
size ]
Command
46-24
Command
channel-number |