Specifying A Description Character String For A Vlan Or Vlan Interface; Creating/Removing A Vlan Interface - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
Table 8-1 Create/Delete a VLAN
Create a VLAN and enter the VLAN view
Delete a specified VLAN
Note that the default VLAN, namely VLAN 1, cannot be deleted.

8.2.2 Specifying a Description Character String for a VLAN or VLAN interface

You can use the following commands to specify a description character string for a
VLAN or VLAN interface.
Perform the following configuration in VLAN view or VLAN interface view.
Table 8-2 Specify a description character string for a VLAN or VLAN interface
Specify a description character string for a
VLAN or VLAN interface
Restore the default description of the
current VLAN or VLAN interface
By default, the description character string of a VLAN is the VLAN ID of the VLAN, such
as VLAN 0001. The description character string of a VLAN interface is the VLAN
interface name, such as Vlan-interface1 Interface.

8.2.3 Creating/Removing a VLAN Interface

You can use the following commands to create/remove a VLAN interface. To implement
the network layer function on a VLAN interface, IP address and mask should be set to
the VLAN interface. For corresponding configuration, refer to "Network protocol" part in
this manual.
Perform the following configuration in system view.
Table 8-3 Create/remove a VLAN interface
Create a new VLAN interface and enter
the VLAN interface view
Remove a specified VLAN interface
Create a VLAN before creating a VLAN interface corresponding to the VLAN.
Operation
Operation
Operation
8-2
Chapter 8 VLAN Configuration
Command
vlan vlan_id
undo vlan { vlan_id [ to vlan_id ] | all }
Command
description string
undo description
Command
interface vlan-interface vlan_id
undo interface vlan-interface vlan_id