Displaying And Debugging Link Aggregation; Link Aggregation Configuration Example - 3Com Switch 4500 26-Port Configuration Manual

54 C 2: P O
HAPTER ORT PERATION
Displaying and
Debugging Link
Aggregation
Link Aggregation
Configuration Example
Perform the following configuration in Ethernet Port View.
Table 49 Configuring Port Priority
Operation
Configure port priority
Restore the default port priority
By default, port priority is 32768.
After the above configuration, enter the
the running of the link aggregation configuration, and to verify the effect of the
configuration.
You can also enter, in User View, the
the port and
debugging
Table 50 Displaying And Debugging Link Aggregation
Operation
Display summary information
of all aggregation groups
Display detailed information of
a specific aggregation group
Display local system ID
Display detailed link
aggregation information at the
port
Clear LACP statistics at the
port
Disable/enable debugging
LACP state machine
Disable/enable debugging
LACP packets
Disable/enable debugging link
aggregation errors
Disable/enable debugging link
aggregation events
Networking Requirement
Switch A connects Switch B with three aggregation ports, numbered as
Ethernet1/0/1 to Ethernet1/0/3, so that incoming/outgoing load can be balanced
among the member ports.
Command
lacp port-priority
port_priority_value
undo lacp port-priority
display
command to clear LACP statistics of
reset
commands to debug LACP.
Command
display link-aggregation summary
display link-aggregation verbose [ agg_id ]
display lacp system-id
display link-aggregation interface {
interface_type interface_number |
interface_name } [ to { interface_type
interface_num | interface_name } ]
reset lacp statistics [ interface {
interface_type interface_number |
interface_name } [ to { interface_type
interface_num | interface_name } ] ]
[ undo ] debugging lacp state [ interface {
interface_type interface_number |
interface_name } [ to { interface_type
interface_num | interface_name } ] ] { {
actor-churn | mux | partner-churn | ptx | rx }* | all }
[ undo ] debugging lacp packet [ interface {
interface_type interface_number |
interface_name } [ to { interface_type
interface_num | interface_name } ] ]
[ undo ] debugging link-aggregation error
[ undo ] debugging link-aggregation event
command in any view to display