Acl Configuration Example - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
Display ACL configuration
Display
information
Display configuration information
of flow template
Clear ACL statistics
The display acl config command only displays the ACL matching information
processed by the CPU. You can use the display qos-interface traffic-statistic
commands to view the ACL matching information during data forwarding.
See the corresponding Command Manual for description of parameters.

32.4 ACL Configuration Example

32.4.1 Advanced ACL Configuration Example
I. Network requirements
The departments in the intranet are connected through 100 Mbps ports of the switches.
The research and development (R&D) department is connected through the port
Ethernet2/1/1. The wage server of the financial department is at 129.110.1.2. The
requirement is to configure ACLs correctly to limit that the R&D department can only
access the wage server at working time from 8:00 to 18:00.
II. Network diagram
President's office
129.111.1.2
Financial Dept
Figure 32-1 Network diagram for advanced ACL configuration
ACL application
Wage server
129.110.1.2
Switch
#4
#3
#2
#1
Administrative Dept
To router
32-11
Chapter 32 ACL Configuration
display acl config { all | acl-number |
acl-name }
display acl running-packet-filter { all |
interface { interface-name | interface-type
interface-num } | vlan vlan-id }
display flow-template [ default | interface
interface-type interface-num | slot slotid |
user-defined]
reset acl counter { all | acl-number |
acl-name }