3Com 8800 Configuration Manual page 682

3Com Switch 8800 Configuration Guide
Logging buffer
snmp
Log file
Note:
The settings in the 7 directions are independent from each other. The settings will take
effect only after enabling the information center.
The info-center of Ethernet Switch has the following features:
Support to output log in 7 directions, i.e., Console, monitor to Telnet terminal,
logbuffer, loghost, trapbuffer, and SNMP log file.
The log is divided into 8 levels according to the significance and it can be filtered
based on the levels.
The information can be classified in terms of the source modules and the
information can be filtered in accordance with the modules.
The output language can be selected between Chinese and English.
1) Sending the configuration information to the loghost.
Table 46-14 Send the configuration information to the loghost
Device
Switch
Loghost
2) Sending the configuration information to the console terminal.
4
5
6
Configuration
Enable info-center
Set the information
output direction to the
loghost
Set information source
Refer to configuration
cases for related log
host configuration
46-11
Chapter 46 System Maintenance and Debugging
logbuf
snmpagent
logfile
Default
Configuration description
value
By default,
Other configurations are valid
info-center
only if the info-center is enabled.
is enabled.
The configuration
loghost on the switch and that on
— loghost must be the same;
otherwise the information cannot
be sent to the loghost correctly.
You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You must
—
turn on
corresponding
defining
information.
— —
about the
the switch of the
module before
output debugging