3Com 8800 Configuration Manual page 239

3Com Switch 8800 Configuration Guide
After you use the peer default-route-advertise command, the local router will send a
default route with the next hop as itself to the peer unconditionally, even if there is no
default route in BGP routing table.
IV. Configuring itself as the next hop when advertising routes
In general, when sending routes to the EBGP peer, the BGP speaker will set the next
hop address of the routing information as the local address. When sending routes to
the IBGP peer, the BGP speaker will not modify the next hop address.
In some networking conditions, when the routes are sent to the IBGP peer, you can
configure the local address of the sender as the next hop, consequently ensuring the
IBGP neighbors can find the correct next hop.
Perform the following configuration in BGP view.
Table 21-12 Configure itself as the next hop when advertising routes
Configure itself as the next hop when
advertising routes
Disable the specification of itself as the
next hop when advertising routes
V. Removing private AS numbers while transmitting BGP update messages
Generally, the AS numbers (public AS numbers or private AS numbers) are included in
the AS paths while transmitting BGP update messages. This command is used to
configure certain outbound routers to ignore the private AS numbers while transmitting
update messages.
Perform the following configuration in BGP view.
Table 21-13 Remove private AS numbers while transmitting BGP update messages
Remove private AS numbers while
transmitting BGP update messages
Include private AS numbers while
transmitting BGP update messages
By default, the private AS numbers are included during BGP update messages
transmission.
The configuration can only be applied to the peer group.
VI. Configuring to send the community attributes to a peer group
Perform the following configuration in BGP view.
Operation
Operation
21-10
Chapter 21 BGP Configuration
Command
peer group-name next-hop-local
undo peer group-name next-hop-local
Command
peer group-name public-as-only
undo peer group-name public-as-only