Configuration Examples Of Sending Log To The Console Terminal - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
Note:
To configure facility, severity, filter and the file syslog.conf synthetically, you can get
classification in great detail and filter the information.

46.5.12 Configuration Examples of Sending Log to the Console Terminal

I. Network requirements
The network requirements are as follows:
Sending the log information of the switch to console terminal
The information with the severity level above informational will be sent to the
console terminal
The output language is English
The modules that allowed to output information are ARP and IP
II. Network diagram
PC PC PC PC
Figure 46-4 Network diagram
III. Configuration procedure
1) Configuration on the switch
Enable info-center.
[SW8800] info-center enable
Configure console terminal log output; allow modules ARP and IP to output information;
the severity level is restricted within the range of emergencies to informational.
[SW8800] info-center console channel console
[SW8800] info-center source arp channel console log level informational
[SW8800] info-center source ip channel console log level informational
Enable terminal display function.
<SW8800> terminal logging
console console console console
Switch Switch Switch Switch
46-32
Chapter 46 System Maintenance and Debugging