3Com Switch 8800 Configuration Guide
Table 46-17 Send the configuration information to the log buffer
Device
Switch
5)
Sending the configuration information to the trap buffer.
Table 46-18 Send the configuration information to the trap buffer
Device
Switch
6)
Sending the configuration information to SNMP
Table 46-19 Send the configuration information to SNMP
Device
Switch
Configuration
Enable info-center
Set the information
output direction to the
logbuffer
Set information source
Configuration
Enable info-center
Set the information
output direction to the
trapbuffer
Set information source
Configuration
Enable
info-center
46-13
Chapter 46 System Maintenance and Debugging
Default
Configuration description
value
By default,
Other configurations are valid
info-center
only if the info-center is enabled.
is enabled.
You can configure the size of the
—
log buffer at the same time.
You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You must
—
turn
on
corresponding
defining
information.
Default
Configuration description
value
By default,
Other configurations are valid
info-center
only if the info-center is enabled.
is enabled.
You can configure the size of the
—
trap buffer at the same time.
You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You must
—
turn
on
corresponding
defining
information.
Default value
Configuration description
By
default,
Other configurations are valid
info-center is
only if the info-center is
enabled.
enabled.
the
switch
of
the
module
before
output
debugging
the
switch
of
the
module
before
output
debugging