3Com Switch 8800 Configuration Guide
Enable/Disable
debugging
Enable/Disable BGP Open debugging
Enable /Disable BGP packet debugging
Enable/Disable BGP Update packet
debugging
Enable/Disable information debugging
of BGP normal functions.
Enable/Disable BGP Update packet
debugging
Reset BGP flap information
21.4 Typical BGP Configuration Example
21.4.1 Configuring BGP AS Confederation Attribute
I. Network requirements
Divide the following AS 100 into three sub-AS: 1001, 1002, and 1003, and configure
EBGP, confederation EBGP, and IBGP.
Operation
BGP
Keepalive
21-26
Chapter 21 BGP Configuration
Command
[ undo ] debugging bgp keepalive
[ receive | send ] [ verbose ]
[ undo ] debugging bgp open [ receive
| send ] [ verbose ]
[ undo ] debugging bgp packet
[ receive | send ] [ verbose ]
[ undo ] debugging bgp route-refresh
[ receive | send ] [ verbose ]
[ undo ] debugging bgp normal
[ undo ] debugging bgp update
[ receive | send ] [ verbose ]
reset
bgp
[
regular-expression
as-regular-expression
acl-number | network-address [ mask ] ]
flap-info
|
as-path-acl