Sending The Configuration Information To Console Terminal - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
Every channel has been set with a default record, whose module name is default and
the module number is 0xffff0000. However, for different channels, the default record
may have different default settings of log, trap and debugging. When there is no
specific configuration record for a module in the channel, use the default one.
Note:
If you want to view the debugging information of some modules on the switch, you must
select debugging as the information type when configuring information source,
meantime using the debugging command to turn on the debugging switch of those
modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information. This configuration will
affect the timestamp of the displayed information.
Perform the following configuration in system view:
Table 46-23 Configure the output format of time-stamp
Configure the output format of the
time-stamp
Output time-stamp is disabled
4) Configuring the loghost
The configuration on the loghost must be the same with that on the switch. For related
configuration, see the configuration examples in the later part.

46.5.4 Sending the Configuration Information to Console terminal

To send configuration information to console terminal, follow the steps below:
1) Enabling info-center
Perform the following configuration in system view.
Table 46-24 Enable/disable info-center
Enable info-center
Disable info-center
Operation
Operation
46-16
Chapter 46 System Maintenance and Debugging
Command
info-center timestamp { log | trap |
debugging } { boot | date | none }
undo info-center timestamp { log |
trap | debugging }
Command
info-center enable
undo info-center enable