Displaying And Debugging Ssh; Ssh Server Configuration Example - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
Perform the following configuration in system view.
Table 50-16 Configure the first-time authentication of the server
Configure the first-time authentication of the server
Cancel the first-time authentication of the server
By default, the client does not perform the first-time authentication.

50.1.4 Displaying and Debugging SSH

On completion of the above configurations, you can use the display command in any
view to view the operation of the configured SSH and further verify the result of the
configurations. You can also debug SSH by performing the debugging command in
user view.
Table 50-17 Display information relevant to SSH
Display the public key of the host key pair and
the server key pair of the server
Display the public key of the specified RSA
key pair of the client
Display the SSH status information and
session information
Display information about the SSH user
Enable SSH debugging
Disable SSH debugging

50.1.5 SSH Server Configuration Example

I. Network requirements
As shown in Figure 50-3, a PC (SSH client) running SSH 2.0-enabled client software
establishes a local connection with the switch (SSH server) to better guarantee the
security of exchanged information.
Operation
Operation
50-13
Chapter 50 SSH Terminal Service
Command
ssh client first-time enable
undo ssh client first-time
Command
display rsa local-key-pair public
display rsa peer-public-key
[ brief | name keyname ]
display ssh server { status |
session }
display ssh user-information
[ username ]
debugging ssh server { vty index
| all }
undo debugging ssh server { vty
index | all }