3Com 8800 Configuration Manual page 81

3Com Switch 8800 Configuration Guide Chapter 7 Link Aggregation Configuration
Enable LACP on Ethernet ports Ethernet2/1/1 to Ethernet2/1/3.
[SW8800] interface ethernet2/1/1
[SW8800-Ethernet2/1/1] lacp enable
[SW8800-Ethernet1/1/1] interface ethernet2/1/2
[SW8800-Ethernet2/1/2] lacp enable
[SW8800-Ethernet2/1/2] interface ethernet2/1/3
[SW8800-Ethernet2/1/3] lacp enable
You must set basic configuration, rate and duplex attribute consistent at both ends to
aggregate successfully the LACP-enabled ports into a dynamic aggregation group and
achieve load sharing.
7-11