Configuring The Ip Address Of The Vlan Interface; Displaying And Debugging Ip Address; Ip Address Configuration Example - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide

11.2.2 Configuring the IP Address of the VLAN Interface

You can configure an IP address for every VLAN interface of the switch. Generally, it is
enough to configure one IP address for an interface. You can also configure ten IP
addresses for an interface at most, so that it can be connected to several subnets.
Among these IP addresses, one is the primary IP address and all others are secondary.
Perform the following configuration in VLAN interface view.
Table 11-3 Configure an IP address for a VLAN interface
Configure an IP address for a VLAN
interface
Delete an IP address of a VLAN
interface
By default, the IP address of a VLAN interface is null.

11.3 Displaying and debugging IP Address

After the above configuration, execute the display command in any view to display the
IP addresses configured on interfaces of the network device, and to verify the effect of
the configuration.
Table 11-4 Display and debug IP address
Display all hosts on the network and the
corresponding IP addresses
Display the configurations of a VLAN
interface

11.4 IP Address Configuration Example

I. Network requirements
Configure the IP address as 129.2.2.1 and subnet mask as 255.255.255.0 for the
VLAN interface 1 of the switch.
Operation
Operation
11-5
Chapter 11 IP Address Configuration
Command
ip address ip-address
mask-length } [ sub ]
undo ip address ip-address { mask |
mask-length } [ sub ]
Command
display ip host
display ip interface vlan-interface
vlan-id
{ mask |