Creating/Updating View Information Or Deleting A View; Setting The Size Of The Snmp Packet Sent/Received By An Agent; Disabling Snmp Agent - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide

47.3.10 Creating/Updating View Information or Deleting a View

You can specify the view to control the access to the MIB by SNMP manager. You can
use either the predefined views or the self-defined views. You can use the following
commands to create, update the information of views or delete a view.
Perform the following configuration in system view.
Table 47-11 Create/Update view information or delete a view
Create/Update
information
Delete a view

47.3.11 Setting the Size of the SNMP Packet Sent/Received by an Agent

You can use the following commands to set the size of SNMP packet sent/received by
an agent.
Perform the following configuration in system view.
Table 47-12 Set the size of the SNMP packet sent/received by an agent
Set the size of the SNMP packet
sent/received by an agent
Restore the default size of the SNMP
packet sent/received by an agent
The agent can receive/send the SNMP packets of the sizes ranging from 484 to 17940,
measured in bytes. By default, the size of an SNMP packet is 1500 bytes.

47.3.12 Disabling SNMP Agent

To disable SNMP Agent, perform the following configuration in system view.
Table 47-13 Disable snmp agent
Disable snmp agent
If users disable NMP Agent, it will be enabled whatever snmp-agent command is
configured thereafter.
Operation
view
Operation
Operation
Chapter 47 SNMP Configuration
Command
snmp-agent mib-view { included | excluded }
view-name oid-tree
undo snmp-agent mib-view view-name
snmp-agent
byte-count
undo snmp-agent packet max-size
undo snmp-agent
47-8
Command
packet max-size
Command