Super Vlan Configuration Example - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide

10.2.2 Super VLAN Configuration Example

I. Network requirements
Super VLAN 10 and sub VLANs including VLAN 2, VLAN 3 and VLAN 5 need
configuring. VLAN2 contains port 1 and 2; VLAN3 contains port 3 and 4; VLAN5
contains port 5 and 6. These sub VLANs are isolated at Layer 2. It is required that these
sub VLANs communicate with each other at Layer 3.
II. Network diagram
Omitted
III. Configuration procedure
[SW8800] vlan 10
[SW8800-vlan10] supervlan
[SW8800-vlan10] vlan 2
[SW8800-vlan2] port ethernet3/1/1ethernet3/1/2
[SW8800-vlan2] vlan 3
[SW8800-vlan3] port Ethernet3/1/3 ethernet3/1/4
[SW8800-vlan3] vlan 5
[SW8800-vlan5] port ethernet3/1/5 ethernet3/1/6
[SW8800-vlan5] vlan 10
[SW8800-vlan10] subvlan 2 3 5
[SW8800-vlan10] interface vlan 10
[SW8800-Vlan-interface10] ip address 10.110.1.1 255.255.255.0
Note:
By default ARP proxy on super VLANs is enabled, and disabled on sub VLANs.
Chapter 10 Super VLAN Configuration
10-3