3Com 8800 Configuration Manual page 461

3com 8800: install guide
Hide thumbs Also See for 8800:
Table of Contents

Advertisement

3Com Switch 8800 Configuration Guide
You can configure a static route pointing to CE on PE for it to learn VPN routing
information from CE.
Perform the following configuration in the system view.
Table 37-14 Configure static route in vpn-instance routing table
Operation
Create
vpn-instance
route
Delete
vpn-instance
route
By default, the preference value for a static route is 60. You can also specify another
preference for the static route you are configuring.
2)
Configure RIP multi-instance
If you select RIP mode for CE-PE route switching, you should then specify running
environment for RIP instance on PE. With this command, you can enter RIP view and
import and advertise RIP instance in the view.
Perform the following configuration in the RIP view.
Table 37-15 Configure PE-CE RIP instance
Create PE-CE RIP instance
Delete PE-CE RIP instance
Then configuring RIP multi-instance to import IBGP route.
For details about RIP configuration, see RIP configuration section in Routing Protocol
of this manual.
3)
Configure OSPF multi-instance on PE
If you select OSPF mode for CE-PE route switching, you should then configure OSPF
multi-instance on PE. Other configurations, such as MPLS basic configuration,
vpn-instance configuration, do not change. Noted that when OSPF routes and
direct-connect routes are imported in the VPN instance address family view, BGP
ip
route-static
a
specific
vpn-instance-name2 ... ip-address { mask | mask-length }
static
{ interface-name | [ vpn-instance vpn-nexthop-name
vpn-nexthop-address ] } [ preference preference-value ]
[ reject | blackhole ]
undo ip route-static vpn-instance vpn-instance-name1
a
specific
vpn-instance-name2 ... ip-address { mask | mask-length }
static
{ interface-name [ vpn-instance vpn-nexthop-name
vpn-nexthop-address ] } [ preference preference-value ]
[ reject | blackhole ]
Operation
Chapter 37 BGP/MPLS VPN Configuration
Command
vpn-instance
Command
ipv4-family
[
unicast
vpn-instance-name
undo ipv4-family [ unicast ] vpn-instance
vpn-instance-name
37-17
vpn-instance-name1
]
vpn-instance

Advertisement

Table of Contents
loading

Table of Contents