Typical Integrated Is-Is Configuration Example - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
Display IS-IS SPF calculation log
Display IS-IS routing information
Display IS-IS neighbor information
Display mesh group information
Enable IS-IS debugging
Disable IS-IS debugging

20.4 Typical Integrated IS-IS Configuration Example

I. Network requirements
As is shown in Figure 20-3, Switches A, B, C and D belong to the same autonomous
system. The IS-IS routing protocol is running in these four switches so as to implement
route interconnection. In the network design, switches A, B, C and D belong to the
same area.
Chapter 20 Integrated IS-IS Configuration
display isis spf-log
display isis route
display isis peer [ verbose ]
display isis mesh-group
debugging isis
authentication-error | checksum-error |
circuit-information | configuration-error |
datalink-receiving-packet
datalink-sending-packet | general-error |
interface-information | memory-allocating |
receiving-packet-content
self-originate-update
sending-packet-content
spf-event | spf-summary | spf-timer |
task-error | timer | update-packet }
undo debugging isis { adjacency | all |
authentication-error | checksum-error |
circuit-information | configuration-error |
datalink-receiving-packet
datalink-sending-packet | general-error |
interface-information | memory-allocating |
receiving-packet-content
self-originate-update
sending-packet-content
spf-event | spf-summary | spf-timer |
task-error | timer | update-packet }
20-25
{ adjacency | all
| snp-packet
| snp-packet
|
|
|
|
|
|
|
|
|