3Com 8800 Configuration Manual page 269

3Com Switch 8800 Configuration Guide
Set the next-hop address of the routing
information
Cancel the next-hop address of the
routing information
Import the route to IS-IS level-1, level-2 or
level-1-2
Remove the function of importing the
route to IS-IS
Set the local preference of the BGP
routing information
Cancel the local preference of the BGP
routing information
Set the routing cost of the routing
information
Cancel the routing cost of the routing
information
Set the cost type of the routing
information
Remove the setting of the cost type
Set the route origin of the BGP routing
information
Cancel the route origin of the BGP routing
information
Set the tag domain of the OSPF routing
information
Cancel the tag domain of the OSPF
routing information
By default, perform no settings.
Note that if the routing information meets the match conditions specified in the
route-policy and also notifies the MED value configured with the apply cost-type
internal when notifying the IGP route to the EBGP peers, then this value will be
regarded as the MED value of the IGP route. The preference configured with the apply
cost-type internal command is lower than that configured with the apply cost
command, but higher than that configured with the default med command.
Operation
22-6
Chapter 22 IP Routing Policy Configuration
Command
apply ip next-hop ip-address
undo apply ip next-hop
apply isis [ level-1 | level-2 |
level-1-2 ]
undo apply isis
apply local-preference
local-preference
undo apply local-preference
apply cost value
undo apply cost
apply cost-type [ internal | external ]
undo apply cost-type
apply origin { igp | egp as-number |
incomplete }
undo apply origin
apply tag value
undo apply tag