Entering Ospf Area View; Specifying An Interface To Run Ospf - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
By default, OSPF is disabled.
When enabling OSPF, pay attention to the following points:
The default OSPF process ID is 1. If no process ID is specified in the command,
the default one is adopted.
If a router is running multiple OSPF processes, you are recommended to use
router-id in the command to specify different router IDs for different processes.

19.2.3 Entering OSPF Area View

OSPF divides an AS into different areas or logical groups of routers.
Perform the following configuration in OSPF view.
Table 19-3 Enter OSPF area view
Enter OSPF area view
Delete an OSPF area
The area-id parameter identifies an area. It can be a decimal integer in the range of 0 to
4,294,967,295, or in the format of IP address. Regardless of how it is specified, it is
displayed in the format of IP address.
Note that when you configure OSPF routers in the same area, you should apply most
configuration data to the whole area. Otherwise, the neighboring routers cannot
exchange information. This may even block routing information or create routing loops.

19.2.4 Specifying an Interface to Run OSPF

After using the ospf command to enable OSPF in system view, you must specify the
network to run OSPF. An ABR router can be in different areas, while a network segment
can only belong to an area. That is, you must specify a specific area for each port
running OSPF.
Perform the following configuration in OSPF area view.
Table 19-4 Specifying an interface to run OSPF
Specify an interface to run OSPF
Disable OSPF on the interface
The ip-mask argument is IP address wildcard shielded text (similar to the complement
of the IP address mask).
Operation
Operation
19-8
Chapter 19 OSPF Configuration
Command
area area-id
undo area area-id
Command
network ip-address ip-mask
undo network ip-address ip-mask