Ldp Configuration; Enabling Ldp Protocol - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
be the ingress node, an intermediate node (also called transit node), or the egress
node. Note that an LSP operates normally only after all the LSRs along the LSP have
been properly configured.
The undo static-lsp command is used to delete a specified LSP established manually.
Perform the following configuration in MPLS view.
Table 36-4 Set the local LSR to a node on a specified LSP
Set the current LSR to the
ingress node of the specified
LSP
Cancel the ingress node
setting of the specified LSP
Set the current LSR to an
intermediate node along the
specified LSP
Cancel the intermediate node
setting of the specified LSP
Set the current LSR to the
egress node of the specified
LSP
Cancel
setting of the specified LSP

36.3 LDP Configuration

The following sections describe the required LDP configuration tasks for MPLS basic
capability:

Enabling LDP protocol

Enabling LDP on VLAN interface
The following sections describe the optional LDP configuration tasks for MPLS basic
capability:
Configuring Remote-Peer for Extended Discovery Mode
Configuring session parameters
36.3.1 Enabling LDP protocol
To configure LDP, first enable LDP.
Perform the following configuration in the system view.
Operation
the egress node
Chapter 36 MPLS Basic Capability Configuration
Command
static-lsp ingress
dest-addr { addr-mask | mask-length } | l2vpn }
nexthop next-hop-addr
out-label-value
undo static-lsp ingress lsp-name
static-lsp transit
incoming-interface interface-type interface-num
in-label in-label-value nexthop next-hop-addr
out-label out-label-value
undo static-lsp transit lsp-name
static-lsp egress
incoming-interface interface-type interface-num
in-label in-label-value
undo static-lsp egress lsp-name
36-3
lsp-name { destination
} } out-label
lsp-name [ l2vpn
lsp-name [ l2vpn
]
]