3Com 8800 Configuration Manual page 686

3Com Switch 8800 Configuration Guide
Table 46-21 Configure to output information to the loghost
Output information to the loghost
Cancel
outputting information to loghost
Note that the IP address of log host must be correct.
Note:
Ensure to enter the correct IP address using the info-center loghost command to
configure loghost IP address. If you enter a loopback address, the system prompts of
invalid address appears.
3) Configuring information source on the switch
By this configuration, you can define the information that sent to console terminal is
generated by which modules, information type, information level, and so on.
Perform the following configuration in system view.
Table 46-22 Define information source
Define information source
Cancel the configuration of
information source
modu-name specifies the module name; default represents all the modules; all
represents all the information filter configuration in channelnum chunnel except default;
level refers to the severity levels; severity specifies the severity level of information.
The information with the level below it will not be output. channel-number specifies the
channel number and channel-name specifies the channel name.
When defining the information sent to the loghost, channel-number or channel-name
must be set to the channel that corresponds to loghost direction.
Operation
the configuration
Operation
Chapter 46 System Maintenance and Debugging
info-center loghost host-ip-addr [ channel
{ channel-number | channel-name } | facility
local-number |
english } ]*
of
undo info-center loghost host-ip-addr
Command
info-center source { modu-name | default }
channel { channel-number | channel-name }
[ debug { level severity | state state }* | log { level
severity | state state }* | trap { level severity | state
state }* ]*
undo info-center source { modu-name | default |
all } channel { channel-number | channel-name }
46-15
Command
language { chinese |